Technical data
N7280
N7280N7280
N7280-
--
-90034
9003490034
90034-
--
-
Rev. A
Rev. ARev. A
Rev. A
System
SystemSystem
System Installation and Verification
Installation and Verification Installation and Verification
Installation and Verification
32
3232
32
a
aa
a Go to the Service environment, Confirmations,
Diagnostics & Adjustments task.
b
bb
b Select Service Folder and click Run Selected
Tests.
5
55
5 Verify a customer board - Request a test panel/board
from the customer (Optional).
a
aa
a If the customer already has Medalist x6000 systems
in place, check a typical application to be used on
this machine (using a golden panel, a reference
panel that serves as a standard unit to which others
can be compared, is preferred).
b
bb
b If this is the first Medalist x6000 on site, manually
set the rail width and verify that the customer's
board will load and unload.
6
66
6 Have the customer complete a back up of the hard drive
— Follow the procedure described in
Backup Strategy in
the System Administration section of the Medalist
x6000 help system.
7
77
7 System cleanup — Using a mild detergent and a clean
white cotton cloth, clean the system exterior removing
any dirt, hand prints, etc.
8
88
8 Turn the audible alarm on — If the customer wants to
have the audible alarm sound when the light tower
indicates red:
a
aa
a Go to the System Configuration Environment,
Production Options task, General tab and check
Enable light stack buzzer in the Production
Options panel.
b
bb
b Set the buzzer dip switch to the tone preferred by
customer.
c
cc
c To test the light stack audible alarm, go to the
Service Environment, Subsystem Status &
Control task, Light Tower tab and click Buzzer
On to turn it on and to verify that the audible alarm
sounds.
9
99
9 Enter the customer and company information into the
Medalist x6000 software.
a
aa
a Go to System Configuration > Customer
Options > Customer Info and fill out the
requested information.
10
1010
10 Install IRP rack covers.
a
aa
a Using a T-25 Torx driver, remove the lower screw,
from both sides of the lower filler panel.