Technical data

ManualsBrandsAgilent Technologies ManualsPower ToolsMedalist x6000

N7280

N7280N7280

N7280-

-90034

9003490034

90034-

Rev. A

Rev. ARev. A

Rev. A

System

SystemSystem

System Installation and Verification

Installation and Verification Installation and Verification

Installation and Verification

2121

Cables must be the stranded type (not solid). Follow local code if it supersedes these instructions.

 A breaker panel near the Medalist x6000

installation area can be used to allow complete

power down in case of an emergency. The E1135C

PDU (Power Distribution Unit) has a rotating,

lockable switch for this as well. Turn this switch to

the off position.

 A standard (local) power outlet should be installed

for additional accessories such as a printer (There

are no extra outlets on the Agilent x6000.)

Figure 18: Power distribution unit

1414

14 Verify power from PDU — Verify the power cords are

connected to the PDU as described by the information in

Figure 19.

Figure 19: PDU rear panel

The auxiliary outlets on the rear of the PDU are

switched outlets and are numbered. The following

components plug into the respective auxiliary outlets as

follows:

NOTE

E1135C

POWER DISTRIBUTION UNIT

OFF

To Mains

Supply

50 Hz

60 Hz

100V

208V

120V

220V

127V

230V

200V

240V