Technical data

N7280

N7280N7280

N7280-

-90034

9003490034

90034-

Rev. A

Rev. ARev. A

Rev. A

System

SystemSystem

System Installation and Verification

Installation and Verification Installation and Verification

Installation and Verification

The system while on its pallet is 2.44 meters or 96 inches high. This height plus the required forklift

lifting distance is needed for (clearance) movement while on the shipping pallet.

4 Move Medalist x6000 To Install Site — When you are

ready, (using acceptable lifting equipment) raise the

Medalist x6000 from its pallet and move to the install

area.

Be very careful while moving the forklift in place to remove the Medalist x6000 from its pallet.

You should do this from the front of the unit and ensure forks protrude entirely through the

frame (you can see them on the other side) to enable secure movement of the system.

5 Staging — Organize all materials in the installation

area. Prior to beginning installation, find the x6000 ship

kit. This kit contains the foot pads and spacers (part

number N7280-80024).

6 Clear Packaging — Remove all remaining items from

the Medalist x6000 pallet. Remove the remaining

packing materials, straps, padding etc. from the

Medalist x6000. Tape is applied to the edges of the

tower door to prevent damage during shipping. Be sure

to remove this tape to ensure a good door seal.

7 Inspect the Medalist x6000 — Inspect the Medalist

x6000 and accessories for damage. Inspect system

exterior for abrasions or dents. Record any damage on

the waybill. Advise the carrier and contact the Agilent

Customer Support Center immediately.

Never use jacks or the forklift on the granite base to raise the system.

For your safety, be sure to coordinate the lowering of the Medalist x6000 onto the threaded

foot pads and spacers with the personnel managing the move. Never place any part of your

body underneath the system while it is on the forklift.

WARNING

CAUTION

NOTE