User`s guide

Protocol Analyzer
Building a Filter
362 5967–9446
To filter by host
1 Choose an option from the Filter➤Host➤ menu.
2 Specify the host(s) to filter.
3 Indicate whether to include or exclude packets matching
the specified host(s).
4 Repeat steps 1 through 3 as needed.
Protocol Analyzer lets you filter host traffic in several ways. The fol-
lowing options are available on the Filter➤Host➤ menu.
You can combine these host filter components as needed; items specified
by the Filter➤Host➤ menu options are connected by logical ORs except
for Source and Destination. For these two, you can specify either a logical
AND or a logical OR. (See figure 74 on page 361.)
Specifying Hosts
When you select an option from the Filter➤Host➤ menu, a window like
the one shown in figure 75 on page 363 appears. This window lets you
specify the criteria for the host filter. Figure 75 shows the Source option;
however, all of the host filters work essentially the same way.
The host filter component windows contain the following items.
See Also man pages: sysnodelist(5), gethostbyname(3N).
ToFrom Filters traffic flowing to or originating from the selected host(s).
Between Filters traffic between one or more selected pairs of hosts.
Source Filters traffic originating from the selected host(s).
Destination Filters traffic flowing to the selected host(s).