User`s guide

Load Monitor
Changing Properties
5967–9446 295
To filter data
1 Select Properties➤Data… from the appropriate Zoom
pop-up menu.
2 Change the Filter data properties as needed.
Filter data properties let you screen out unwanted data values, letting
you focus on the information you want to see.
The available filter options depend on which Zoom element’s properties
you are changing. Figure 69 on page 297 shows the Filter data properties
for the Source graph.
You can change the following Filter data properties.
Select
Source Nodes…
Destination
Nodes…
Conversation
Pairs…
Nodes…
Protocols…
Lets you include or exclude a specified list of node addresses, between
pairs, or protocols. Items that are not shown in the graph are
accumulated in the “Others” item, which can be suppressed by turning
off the Show “others” toggle.
For Conversation graphs, you can select individual nodes or
conversation pairs.
Figure 69 on page 297 shows the Source filter properties and the Source
Nodes… filter window and selection list. The other Select options work
in a similar fashion.
When displaying Protocol as a pie graph, any information configured
with the Protocols… button is ignored.
Note: Select works with Standard RMON only.The Select button is not
available when viewing extended data.
Show “others” Indicates whether to display the “others” item, which combines values
not shown as individual entries.
The Show “others” toggle is available only when viewing extended data.