Technical data

margins. If the margins are not defined in the input file, then the output is
NOMARGIN, and the margin SCPIs are ineffective.
Example:
MARGIN,DISP,8.0E-10,2.222222222222E-10
:MEASure:EMASk(*):MASK:STARt
:MEASure:EMASk(*):MASK:STARt
This aligns the mask according to the parameters set in either the mask file, or the
mask properties tab. Then it starts counting the mask violations.
None
None
:MEASure:EMASk(*):MASK:STOP
:MEASure:EMASk(*):MASK:STOP
Stops counting the mask violations.
None
None
:MEASure:EMASk(*):MASK:MARGin
:MEASure:EMASk(*):MASK:MARGin
:MEASure:EMASk(*):MASK:MARGin?
The mask definition in the loaded mask file is used to calculate the coordinates of
the margin. The mask margin stretches, and shrinks the mask. There is a maximum
margin, and a minimum margin defined in the mask file.
An input value within the range of -100 to 100.
5 SCPI Command Reference
386 Agilent J-BERT N4903B High-Performance Serial BERT
Syntax
Description
Input
Output
Syntax
Description
Input
Output
Syntax
Description
Input