Technical data

Setting Up Data Points
When you create a measurement object, the object is set up by default with six
symmetrically placed data points, as shown in the following figure:
These settings can be changed, and up to 32 measurement points can be defined.
For this, you would first change the number of measurement points, and then
specify each of the points as required.
Running the Fast Eye Mask - Procedures
The following code indicates how you could set up and run the Fast Eye Mask
using SCPI.
N O T E
The Fast Eye Mask measurement displayed in the user interface cannot be
controlled remotely. When you set up a program to run a Fast Eye Mask
measurement remotely, a separate measurement object is created. Any
programmatical changes to this measurement object will not be reflected in the
user interface.
Prepare the Measurement
To create the measurement object and prepare the measurement:
1
Create the session:
meas:fem:cre?
3 Recommended Programming Techniques
36 Agilent J-BERT N4903B High-Performance Serial BERT