Technical data

In this case, it is recommended that you redefine the pattern. This error can
only occur with memory-based patterns.
• BURST_RESULT_STATE__UNKNOWN
The status is unknown. This can occur if accumulation has not been started,
or if Burst Sync mode has not been activated.
N O T E
Please note that the responses each have two underscores after STATE.
[P]FETCh[:SENSe[1]]:ECOunt Subnode
This subnode has the following SCPI structure:
[P]FETCh
[:SENSe[1]]
:ECOunt
[:ALL]
[:FULL]
[:TOTal]?
:DELTa?
:OASZero
[TOTal]?
:ZASone
[:TOTal]?
This subnode has the following commands:
Table 72
Name Description under
:ECOunt[:ALL][:FULL][:TOTal]? “[P]FETCh[:SENSe[1]]:ECOunt[:ALL]
[:FULL][:TOTal]? ” on page 292
:ECOunt[:ALL][:FULL]:DELTa? “[P]FETCh[:SENSe[1]]:ECOunt[:ALL]
[:FULL]:DELTa? ” on page 292
:ECOunt:OASZero[:TOTal]? “[P]FETCh[:SENSe[1]]:ECOunt:OASZero
[:TOTal]? ” on page 292
:ECOunt:ZASone[:TOTal]? “[P]FETCh[:SENSe[1]]:ECOunt:ZASone
[:TOTal]? ” on page 292
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 291