Technical data

Table 68
Name Description under
:FREQuency:CDR:AUTO[?] “SENSe2:FREQuency:CDR:THReshold:A
UTO[?]” on page 278
:FREQuency:CDR:THReshold[:VALue][?] “SENSe2:FREQuency:CDR:THReshold
[:VALue][?]” on page 278
:FREQuency:CDR:THReshold:MEASure
[?]
“SENSe2:FREQuency:CDR:THReshold:
MEASure[?]” on page 278
:VOLTage:EDGe[?] “SENSe2:VOLTage:EDGe[?] ” on page
279
N O T E
Depending on the options of your Serial BERT, the commands relating to clock data
recovery (CDR) may not be available. See the online Help or the User's Guide for a
description of the available options.
SENSe2:FREQuency[:CW|:FIXed]?
IAgilentN490xEDClockIn.GetFrequency (IVI-compliant)
SENSe2:FREQuency[:CW|:FIXed]?
This query returns the internal clock source frequency. You can use any of the
forms listed below:
• SENSe2:FREQuency?
• SENSe2:FREQuency:CW?
• SENSe2:FREQuency:FIXed?
These forms have the same effect.
SENSe2:FREQuency:CDR[?]
IAgilentN490xEDCDR.Enabled (not IVI-compliant)
SENSe2:FREQuency:CDR ON | OFF
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 273
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax