Technical data

This command sets the conversion factor for the error detector's Data In port.
Conversion factor is used to calculate the calculated Bit Error Ratio.
N O T E
Conversion factor should always be in the multiple of 10; for example, 10, 20, 30 and
so on.
This query returns the present values.
SENSe[1]:SFError:CFACtor:MODe[?]
SENSe[1]:SFError:CFACtor:MODe AUTo | USEr
SENSe[1]:SFError:CFACtor:MODe?
For example;
SENS1:SFE:CFAC:MOD AUT
This command sets the mode of the conversion factor to either automatic or user
defined. For cBER calculations based on SER, DER, ISR, value for conversion factor
in AUTo and USEr mode is 10. For cBER calculations based on FER and FSR, value
for conversion factor in AUTo mode is the Block Length with Filler Symbols while
for USEr mode, it can be defined.
This query returns the present mode.
SENSe[1]:SFError:ASYMbol[?]
SENSe[1]:SFError:ASYMbol
SENSe[1]:SFError:ASYMbol?
For example;
SENS1:SFE:ASYM "K28.5"
This command sets the alignment symbol for the initial 10b alignment phase on
the error detector's Data In port. The allowed alignments symbols are K28.1, and
K28.5. This query returns the present values.
SENSe[1]:SFError:ASYMbol:MODe[?]
SENSe[1]:SFError:ASYMbol:MODe AUTo | MANual | REALign
5 SCPI Command Reference
268 Agilent J-BERT N4903B High-Performance Serial BERT
Description
Syntax
Description
Syntax
Description
Syntax