Technical data

Sets the starting bit address of a bit address range for error location. The query
returns the current value. This command only has an effect if the BLOCk option is
set with the SENSe[1]:BLOCk command.
This value must be in the range: 0 ... pattern length - 1. Values out of range are set
to the maximum value silently.
SENSe[1]:BLOCk:BLENgth[?]
IAgilentN490xEDErrorLocation.BlockLength (not IVI-compliant)
SENSe[1]:BLOCk:BLENgth <NR1>
SENSe[1]:BLOCk:BLENgth?
Sets the length of a bit address range for error location. The query returns the
current value. This command only has an effect if the BLOCk option is set with the
SENSe[1]:BLOCk command.
This value must be in the range: 1 ... (pattern length - one). Zero is set to 1 silently.
Values beyond the maximum value are set to the maximum value silently.
N O T E
The length is interpreted round cycled.
SENSe[1]:ELOCation Subnode
This subnode has the following SCPI structure:
SENSe[1]
:ELOCation[?]
:BEADdress[?]
:VERBose?
:ECOunt?
N O T E
The Error Location Capture is disabled in "8B/10B Comparison" and "Bit
Comparison without PCIe3 SKPOS" error ratio modes. Therefore all the SCPI
commands under this subnode will not show any results, if you are in "8B/10B
Comparison" and "Bit Comparison without PCIe3 SKPOS" error ratio modes.
This subnode has the following commands:
5 SCPI Command Reference
234 Agilent J-BERT N4903B High-Performance Serial BERT
Description
IVI-COM Equivalent
Syntax
Description