Technical data

SENSe[1]:MRErrors:COUNt[:VALue][?]
SENSe[1]:MRErrors:COUNt[:VALue] 1 | 0
SENSe[1]:MRErrors:COUNt[:VALue]?
This command sets the counter to count bit error when error detector loses sync.
If the counter is set to 0, then the error counter will always count zero bit error. If
the counter is set to 1, then the error counter will always count one bit error
(respectively symbol or frame error in the case of SER/FER). By default, the counter
is set to 1.
The query returns the present counter value (0 or 1).
SENSe[1]:MRErrors:COUNt:LIST?
SENSe[1]:MRErrors:COUNt:LIST?
This query returns a comma separated list which provides the allowed range of the
counting errors when error detector loses sync. At this point of time, the following
counters are allowed 0, 1.
SENSe[1]:BLOCk Subnode
This subnode has the following SCPI structure:
SENSe[1]
:BLOCk[?]
BSTart[?]
BLENgth[?]
This subnode has the following commands:
Table 52
Name Description under
:BLOCk[?] “SENSe[1]:BLOCk[?]” on page 233
:BLOCk:BSTart[?] “SENSe[1]:BLOCk:BSTart[?]” on page
233
:BLOCk:BLENgth[?] “SENSe[1]:BLOCk:BLENgth[?]” on page
234
5 SCPI Command Reference
232 Agilent J-BERT N4903B High-Performance Serial BERT
Syntax
Description
Syntax
Description