Technical data

SENSe[1]:SYNChronizat[?]
IAgilentN490xEDSynchronisation.AutoEnabled (IVI-compliant)
SENSe[1]:SYNChronizat ONCE | 0 | 1 | OFF | ON
SENSe[1]:SYNChronizat?
These commands configure the settings that control synchronization of the
reference pattern to the incoming pattern.
• SENSe[1]:SYNChronizat ON enables automatic resynchronization.
• SENSe[1]:SYNChronizat OFF disables automatic resynchronization.
• SENSe[1]:SYNChronizat ONCE initiates a resynchronization attempt.
The query returns the current selection of the pattern synchronization.
SENSe[1]:SYNChronization:THReshold[?]
IAgilentN490xEDSynchronisation.Threshold (IVI-compliant)
SENSe[1]:SYNChronization:THReshold
SENSe[1]:SYNChronization:THReshold?
SENSe[1]:SYNChronizat:THReshold <NR3>
SENSe[1]:SYNChronizat:THReshold?
This command sets the threshold level of error ratio at which synchronization is
successful.
N O T E
The valid values are 1E-01 thru 1E-08 in decade steps.
The query returns the threshold level of error ratio at which synchronization is set.
SENSe[1]:FREQuency[:CW|:FIXed][?]
IAgilentN490xEDCDR.Frequency (not IVI-compliant)
SENSe[1]:FREQuency[:CW|:FIXed] <Num>
5 SCPI Command Reference
228 Agilent J-BERT N4903B High-Performance Serial BERT
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax