Technical data

Table 50
Name Description under
:SYNChronization[?] “SENSe[1]:SYNChronizat[?] ” on page
228
:SYNChronization:THReshold[?] “SENSe[1]:SYNChronization:THReshold
[?] ” on page 228
:FREQuency[:CW|:FIXed][?] “SENSe[1]:FREQuency[:CW|:FIXed][?] ”
on page 228
:AUXout:MODE[1][?] “SENSe[1]:AUXout:MODE[?] ” on page
229
:ERMode:MODe[?] “SENSe[1]:ERMode:MODe[?]” on page
230
Subnodes
:MRErrors “SENSe[1]:MRErrors Subnode” on page
231
:BLOCk “SENSe[1]:BLOCk Subnode” on page
232
:ELOCation “SENSe[1]:ELOCation Subnode” on page
234
The Error Location Capture is disabled in
"8B/10B Comparison", "Bit Comparison
without PCIe3 SKPOS" and "Bit
Comparison without USB3.1 SKPOS"
error ratio modes. Therefore all the SCPI
commands under this subnode will not
show any results, if you are in "8B/10B
Comparison", "Bit Comparison without
PCIe3 SKPOS" and "Bit Comparison
without USB3.1 SKPOS" error ratio
modes.
:EYE “SENSe[1]:EYE Subnode” on page 238
:GATE “SENSe[1]:GATE Subnode” on page
243
5 SCPI Command Reference
226 Agilent J-BERT N4903B High-Performance Serial BERT