Technical data

Table 48
Name Description under
[:STATe][?] “SOURce8[:JITTer]:RSSClocking
[:STATe][?] ” on page 219
:DISTribution[?] “SOURce8
[:JITTer]:RSSClocking:DISTribution[?] ”
on page 219
:FREQuency[?] “SOURce8
[:JITTer]:RSSClocking:FREQuency[?] ”
on page 220
:LEVel[?] “SOURce8[:JITTer]:RSSClocking:LEVel
[?] ” on page 220
SOURce8[:JITTer]:RSSClocking[:STATe][?]
IAgilentN490xJResidualSpreadSpectrum.Enable
SOURce8:RSSClocking[:STATE] ON | OFF | 1 | 0
:SOUR8:RSSC?
Turns the corresponding jitter source on or off.
SOURce8[:JITTer]:RSSClocking:DISTribution[?]
IAgilentN490xJResidualSpreadSpectrum.Distribution
SOURce8:RSSClocking:DISTribution DATA | CLOCK | BOTH
SOUR8:RSSC:DIST?
The residual SSC signal can be applied to the Data Output, Clock Output or to both
outputs of the generator. If the residual SSC source is switched on, this SCPI
command defines which output(s) will be directly influenced by the residual SSC
signal.
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 219
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Description