Technical data

SOURce8:SINusoidal:FREQuency <NR3>
SOUR8:SIN:FREQ? MIN | MAX
Sets the frequency of the SINusoidal jitter in Hz.
The query returns the present setting or the applicable min/max values.
SOURce8[:JITTer]:SINusoidal:LEVel[?]
IAgilentN490xJSinoidal.Amplitude
SOURce8:SINusoidal:LEVel <NR3>
SOUR8:SIN:LEV? MIN | MAX
The command sets the SINusoidal jitter peak-to-peak level in unit intervals (UI).
Note that the maximum level depends on the jitter frequency.
The query returns the present setting or the applicable min/max values in UI.
SOURce8[:JITTer]:SINusoidal:DISTribution[?]
IAgilentN490xJSinoidal.Distribution
SOURce8:SINusoidal:DISTribution
SOUR8:SIN:DIST? DATA | CLOCk | BOTH
The Sinusoidal Jitter source can be applied to the Data Output, Clock Output or to
both outputs of the generator. If the Sinusoidal Jitter source is switched on, this
SCPI command defines which output(s) will be directly influenced by the Sinusoidal
Jitter signal.
5 SCPI Command Reference
216 Agilent J-BERT N4903B High-Performance Serial BERT
Syntax
Description
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Description