Technical data

SOURce8[:JITTer]:PERiodic2:SWEep:LEVel[:VALue][?]
SOUR8[:JITT]:PER2:SWE:LEV[:VAL] CONS | VAR
SOUR8[:JITT]:PER2:SWE:LEV[VAL]?
The command defines whether a sweep is defined with CONStant jitter level
(amplitude) SCPI commands (SOUR8 [:JITT]:PER2:SWE:FREQ:STAR; SOUR8
[:JITT]:PER2:SWE:FREQ:STOP) or with the user defined VARiable jitter level
(amplitude) SCPI command (SOUR8[:JITT]:PER2:SWE:DATA). If CONSant is
selected the SOUR8[:JITT]:PER2:LEV defines the jitter level of the sweep.
The query returns the present setting.
SOURce8[:JITTer]:PERiodic2:SWEep:PLOT[:VALue]?
SOUR8[:JITT]:PER2:SWE:PLOT[:VAL]?
The query returns a comma separated list (specified as expression) of frequency/
jitter amplitude value pairs. This list of values represents the ‘real’ steps performed
by the PJ sweep..
SOURce8[:JITTer]:PERiodic2:SWEep:DATA[:VALue][?]
SOUR8[:JITT]:PER2:SWE:DATA[:VAL] { Expression }
Example: SOUR8[:JITT]:PER2:SWE:DATA[:VAL] (900.0,1.2,100e3,0.5)
SOUR8[:JITT]:PER2:SWE:DATA[:VAL]?
Every point of the periodic jitter sweep curve can be specified by a group of 2 value
pairs {(Frequency, JitterLevel, …)} separated by a comma. This command defines
the list of value pairs as an SCPI expression; e.g. …: DATA (900.0,1.2,100e3,0.5) or
the value pairs can be separated by additional parenthesis too …:DATA ((900.0,1.2),
(100e3,0.5)). The number of points to be set is limited to 100.
The query returns the present setting.
SOURce8[:JITTer]:PERiodic2:SWEep:STANdard[:SELect][?]
SOUR8[:JITT]:PER2:SWE:STAN[:SEL] { Standard }
Example: SOUR8[:JITT]:PER2:SWE:STAN[:SEL] PCI3
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 213
Syntax
Description
Syntax
Description
Syntax
Description
Syntax