Technical data

The command selects the characteristics of the periodic jitter.
The query returns the present setting (SIN | SQU | TRI).
SOURce8[:JITTer]:PERiodic(*):LEVel[?]
IAgilentN490xJPeriodic.Amplitude
IAgilentN490xJSecondPeriodic.Amplitude
SOURce8:PERiodic(*):LEVel <NR3>
SOUR8:PER1:LEV? MIN | MAX
SOUR8:PER2:LEV? MIN | MAX
The command sets the periodic jitter peak-to-peak level in unit intervals (UI).
The query returns the present setting or the applicable min/max values in UI.
SOURce8[:JITTer]:PERiodic2:SWEep[:STATe][?]
SOUR8[:JITT]:PER2:SWE[:STAT] STAR | STOP 1| 0
SOUR8[:JITT]:PER2:SWE[:STAT]?
The command turns on the periodic jitter 2 sweep.
N O T E
Ensure that Jitter as well as the Periodic Jitter 2 are switched on, otheriwse this
command will stand ineffective.
The query returns the present setting.
SOURce8[:JITTer]:PERiodic2:SWEep:FREQuency:STARt[?]
SOUR8[:JITT]:PER2:SWE:FREQ:STAR <NR3>
SOUR8[:JITTer]:PER2:SWE:FREQ:STAR?
The command defines the start frequency of the periodic jitter sweep. This
command works only if SOUR8[:JITT]:PER2:SWE:LEV[:VAL] CONS is selected.
5 SCPI Command Reference
210 Agilent J-BERT N4903B High-Performance Serial BERT
Description
IVI-COM Equivalent
Syntax
Description
Syntax
Description
Syntax
Description