Technical data

SOURce8[:JITTer]:PERiodic(*)[:STATe][?]
IAgilentN490xJPeriodic.Enable
IAgilentN490xJSecondPeriodic.Enable
SOURce8:PERiodic(*)[:STATE] ON | OFF | 1 | 0
SOUR8:PER1:STAT
SOUR8:PER2:STAT
The command turns the generation of periodic jitter on or off.
The query returns the present setting (0 | 1).
SOURce8[:JITTer]:PERiodic(*):FREQuency[?]
IAgilentN490xJPeriodic.ModulationFrequency
IAgilentN490xJSecondPeriodic.ModulationFrequency
SOURce8:PERiodic(*):FREQuency <NR3>
SOUR8:PER1:FREQ? MIN | MAX
SOUR8:PER2:FREQ? MIN | MAX
The command sets the frequency of the periodic jitter in Hz.
Note that the maximum frequency depends on the selected waveform (see
“SOURce8[:JITTer]:PERiodic(*):FUNCtion[:SELect][?] ” on page 209).
The query returns the present setting or the applicable min/max values.
SOURce8[:JITTer]:PERiodic(*):FUNCtion[:SELect][?]
IAgilentN490xJPeriodic.WaveForm
IAgilentN490xJSecondPeriodic.WaveForm
SOURce8:PERiodic(*):FUNCtion[:SELect] SINusoid | SQUare | TRIangle
SOUR8:PER1:FUNC?
SOUR8:PER2:FUNC?
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 209
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax