Technical data

SOURce8[:JITTer]:PERiodic(*) Subnode
The new JBert B hardware has two Periodic Jitter; Periodic Jitter (PJ1) and
Periodic Jitter (PJ 2), which are generated by a built-in function generator. Sine,
square, and triangle waveforms are available.
This subnode has the following SCPI structure:
:SOURce8[:JITTer]
:PERiodic(*)
[:STATe][?]
:SWEep
:FREQuency[?]
:FUNCtion[:SELect][?]
:LEVel[?]
:PLOT
:DATA
:STARt[?]
:STOP[?]
[:STATe][?]
:LEVel
:FREQuency
:TIME[?]
:STEP
:DISTance[?]
:STANdard
[:SELect][?]
[:VALue][?]
[:VALue][?]
[:VALue]?
[:VALue][?]
This subnode has the following commands:
Table 45
Name Description under
[:STATe][?] “SOURce8[:JITTer]:PERiodic(*)[:STATe]
[?] ” on page 209
:FREQuency[?] “SOURce8[:JITTer]:PERiodic
(*):FREQuency[?] ” on page 209
:FUNCtion[:SELect][?] “SOURce8[:JITTer]:PERiodic
(*):FUNCtion[:SELect][?] ” on page 209
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 207