Technical data

Table 42
Name Description under
:CONF:DELay[?] “SOURce8[:JITTer]:CONF:DELay[?] ” on
page 199
SOURce8[:JITTer]:CONF[:TYPE][?]
IAgilentN490xJitter.DistributionMode
SOURce8:CONFigure[:TYPE] DL1 | DL2
SOUR8:CONF?
Selects one of the two lines.
• DL1 provides a delay of up to 220 ps.
• DL2 provides a delay of up to 610 ps. This delay line can be used for data rates
up to 3.5 GBit/s.
That means, the command SOURce8:CONF DL2 returns an error if the data rate
is above 3.5 GBit/s.
The query returns the present setting (DL1 | DL2).
SOURce8[:JITTer]:CONF:DISTribution[?]
IAgilentN490xJitter.Distribution
SOURce8:CONFigure:DISTribution DATA | CLOCk | BOTH
SOUR8:CONF:DIST?
Different jitter types e.g. Periodic Jitter, Random Jitter, etc. can be applied to the
Data Output, Clock Output or to both outputs of the generator. If a jitter source is
switched on, this SCPI command defines which output(s) will be directly influenced
by the jitter signal.
SOURce8[:JITTer]:CONF:DELay[?]
IAgilentN490xJitter.Delay
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 199
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent