Technical data

SOURce8[:JITTer]:EXTernal:REMaining:LEVel?
IAgilentN490xJExternal.GetMaxVoltage
SOURce8[:JITTer]:EXTernal:REMaining:LEVel?
This command returns the maximum voltage swing that is allowed for the External
Jitter Modulation Signal.
SOURce8[:JITTer]:GLOBal[:STATE][?]
IAgilentN490xJitter.Enable
SOURce8:GLOBal[:STATE] ON | OFF | 1 | 0
SOUR8:GLOB?
Enables or disables the jitter generation. Refers to random, bounded uncorrelated,
periodic, sinusoidal, and external jitter. Has no effect on spread spectrum clocking.
The query returns the present setting (0 | 1).
SOURce8[:JITTer]:CONFigure Subnode
This subnode has the following SCPI structure:
This subnode has the following commands:
Table 42
Name Description under
:CONF[:TYPE][?] “SOURce8[:JITTer]:CONF[:TYPE][?] ” on
page 199
:CONF:DISTribution[?] “SOURce8[:JITTer]:CONF:DISTribution
[?] ” on page 199
5 SCPI Command Reference
198 Agilent J-BERT N4903B High-Performance Serial BERT
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Description