Technical data

An external clock signal applied to the External Input can be divided by a factor
specified by this SCPI command. This factor is only valid in the External PLL mode
and the allowed range is 1 up to 255.
SENSe6:EXTernal:PLLoop:MULTiplier[?]
IAgilentN490xPGClockIn.ExternalDividerMultiplierPLL
SENSe6:EXTernal:PLLoop:MULTiplier[?]
SENSe6:EXT:PLL:MULT[?]
<NR1>
<NR1>
An external clock signal applied to the External Input can be multiplied by a value
specified by this SCPI command. This value is only valid in the External PLL mode
and the allowed range is 1 up to 255. It can be used in combination with
the :SENS6:EXT:PLL:DIV <NR1> to specify data rates tailored to particular needs
e.g. data rate of the instrument = applied external clock * 5 / 7.
SOURce8 Subsystem
SOURce8 Subsystem - Reference
The SOURce8 subsystem controls the pattern generator's Jitter Setup. This chapter
refers only to Agilent N4903 Serial BERT instruments on which the calibrated and
integrated jitter injection option J10 is installed.
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 195
Description
IVI-COM Equivalent
Syntax
Input Parameters
Return Range
Description