Technical data

OUTPut2:TERMination[?]
IAgilentN490xPGClockVoltageVTermination
OUTPut2:TERMination 0 | -2 | 1.3
OUTPut2:TERMination?
This command sets the data termination level of the pattern generator's Clock Out
port. The response form returns the data termination level.
This command is only valid if the coupling is set to DC (see “OUTPut2:COUPling[?]
” on page 172).
OUTPut2:DCYCle[?]
IAgilentN490xDCYCle
OUTPut2:DCYCle
OUTPut2:DCYCle?
<NR3>
This SCPI command specifies the duty cycle of the clock output when used as a
half rate clock. See also “SOURce2:DIVider[?] ” on page 170.
SOURce3 Subsystem
SOURce3 Subsystem - Reference
The SOURce3 Subsystem represents the pattern generator's Trigger/Ref Clock Out
port.
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 173
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Input Parameters
Description