Technical data

SOURce2:VOLTage:PROT:RES?
This command reset the protection circuit to normal operation at the Clock Output
channel.
SOURce2:VOLTage:PROTection[:STATe][?]
IAgilentN490xPGClockVoltage.ProtectionState (not IVI-compliant)
SOURce2:VOLTage:PROTection[:STATe] ON | OFF
SOURce2:VOLTage:PROT:STAT?
This command gets the state of the protection circuit at the Clock Output channel.
The 'ON' state indicates a triggered protection circuit or in other words the output
is disabled and no signal comes out.
SOURce2:DIVider[?]
IAgilentN490xPGClock.DIVider
SOURce2:DIVider
SOURce2:DIVider?
<NR1> 1, 2
1, 2
This command is used to set the clock out divider. The allowed values are 1 and 2
depending on the data rate settings. For the forward clocking application, a half
rate clock is required. This SCPI command specifies the corrosponding divider. See
also: “OUTPut2:DCYCle[?] ” on page 173.
5 SCPI Command Reference
170 Agilent J-BERT N4903B High-Performance Serial BERT
Description
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Input Parameters
Return Range
Description