Technical data

SOURce9:OUTPut[:STATe]?
This command can be used to switch the pattern generator's clock generator input
from internal to external mode. It is provided for compatibility reasons and is
identical with “SENSe6:MODE ” on page 193. The latter should be preferred.
SOURce9:SSCLocking[:STATe][?]
IAgilentN490xPGSpreadSpectrumEnable
SOURce9:SSCLocking[:STATe] ON | OFF | 1 | 0
SOUR9:SSCL?
Turns the spread spectrum clock modulation on or off.
The query returns the present setting (0 | 1).
SOURce9:SSCLocking:DEViation[?]
IAgilentN490xPGSpreadSpectrum.ModulationRange
SOURce9:SSCLocking:DEViation <NR3>
SOUR9:SSCL:DEV? MIN | MAX
Specifies the maximum deviation from the currently set clock rate towards lower
frequencies. The deviation depends on the selected type, see
“SOURce9:SSCLocking:DEViation:TYPE[?]” on page 163.
The query returns the present setting or the applicable min/max values.
SOURce9:SSCLocking:DEViation:TYPE[?]
IAgilentN490xPGSpreadSpectrum
SOURce9:SSCLocking:DEViation:TYPE[?]
SOUR9:SSCL:DEV:TYPE? DOWNspread | UPSPread | CENTerspread
This command specifies the way the frequency of the clock or data will be
modulated. It can downspread, upspread or centerspread. Downspread is the
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 163
Description
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax
Description