Technical data

OUTPut[1]:CLOCk[:ENABle][?]
OUTPut[1]:CLOCk[:ENABle] 0 | 1 | OFF | ON
OUTPut[1]:CLOCk[:ENABle]?
This command is applicable for N4916B. The command enables the clock multiplier
feature. This feature is only available if a N4916B is connected via USB to a J-BERT
B. For more information on how to connect this box with the J-BERT B, refer to
the Getting Started Guide.
The query returns the present state.
N O T E
The clock multiplier feature is only evailable if a N4916B is connected via USB to a
J-BERT B.
OUTPut[1]:CLOCk:FREQuency[:VALue][?]
OUTPut[1]:CLOCk:FREQuency[:VALue] <NR3>
OUTPut[1]:CLOCk:FREQuency[:VALue]?
This command is applicable for N4916B. The command specifies the input
frequency value that is provided at the input connector of the clock multiplier. See
also, “OUTPut[1]:CLOCk:FREQuency:TRACk[?]” on page 158.
The query returns the present frequency value in floating point format.
OUTPut[1]:CLOCk:FREQuency:TRACk[?]
OUTPut[1]:CLOCk:FREQuency:TRACk 0 | 1 | OFF | ON
OUTPut[1]:CLOCk:FREQuency:TRACk?
This command is applicable for N4916B. The command enables an automatic
update of the frequency if the clock multiplier is connected to a clock delivered by
Serial BERT. In other words, if the data rate of the Serial BERT is changed, the new
value will be store to the connected box.
If the Track PG Clock Frequency check box is not selected, then you can provide
the values of the clock multiplier. Following are the valid values:
• Multiplier: 1 Freq Range : 1GHz to to 13.5GHz
• Multiplier: 2 Freq Range : 1GHz to to 6.75GHz
5 SCPI Command Reference
158 Agilent J-BERT N4903B High-Performance Serial BERT
Syntax
Description
Syntax
Description
Syntax
Description