Technical data

OUTPut[1]:MULTiplexer:DEEMphasis:SELect:PRESet[?]
OUTPut[1]:MULTiplexer:DEEMphasis:SELect:PRESet < NRf >
OUTPut[1]:MULTiplexer:DEEMphasis:SELect:PRESet?
This command is applicable for M8061A. The command sets the value of preset
selection. The preset value is always set to 1.
The query returns the present setting.
OUTPut[1]:MULTiplexer:DEEMphasis:PRECursor(1-2)[?]
OUTPut[1]:MULTiplexer:DEEMphasis:PRECursor1|2 < NRf >
OUTPut[1]:MULTiplexer:DEEMphasis:PRECursor1|2?
This command is applicable for M8061A. The M8061A can generate two pre-
cursors. The command changes the value of pre-cursor 1 or pre-cursor 2. The value
is interpreted as decible (dB) or percentage (%) depending on the specified
deemphasis unit and returned accordingly.
The query returns the present pre-cursor value in floating point format. The value
refers to the current deemphasis unit.
OUTPut[1]:MULTiplexer:DEEMphasis:POSTcursor(1-5)[?]
OUTPut[1]:MULTiplexer:DEEMphasis:POSTcursor1|2|3|4|5 < NRf >
OUTPut[1]:MULTiplexer:DEEMphasis:POSTcursor1|2|3|4|5?
This command is applicable for M8061A. The M8061A can generate five post-
cursors. The command changes the value of post-cursor 1 up to post-cursor 5. The
value is interpreted as decible (dB) or percentage (%) as specified by the
deemphasis unit and returned accordingly.
The query returns the present post-cursor values in floating point format. The value
refers to the current deemphasis unit.
OUTPut[1]:MULTiplexer:TRIGger[:SOURce][?]
OUTPut[1]:MULTiplexer:TRIGger CLK | AUX
OUTPut[1]:MULTiplexer:TRIGger?
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 151
Syntax
Description
Syntax
Description
Syntax
Description
Syntax