Technical data

This command enables/disables the electrical idle feature of the Data Output. The
Error Input can be used to provide an electrical idle (or out of band signaling) signal
at the Data Output. An external generated signal e.g. by a pulse generator at the
Error Input controls the output stream at the Data Output.. If this STATe is set to
ON, error insertion is not possible.
OUTPut[1]:DEEMphasis Subnode
This subnode has the following SCPI structure:
:DEEMphasis
:ENABle[?]
:MODE[?]
[:VALUe][?]
:IDN?
:UPDate[?]
:PRECursor[?]
:POSTcursor(*)[?]
:OPTion?
:INPut[:SAMPle]:ADJust[?]
Commands applicable for N4916A/B
Commands applicable for N4916B
The commands included in this subnode are applicable for N4916A/B only. The
commands to set the deemphasis values for Agilent M8061A can be found at
“OUTPut[1]:MULTiplexer Subnode” on page 145. This subnode has the following
commands:
Table 31
Name Description under
Commands applicable for N4916A/B
:DEEMphasis:ENABle[?] “OUTPut[1]:DEEMphasis:ENABle[?] ”
on page 141
:DEEMphasis:MODE[?] “OUTPut[1]:DEEMphasis:MODE[?] ” on
page 141
:DEEMphasis[:VALue][?] “OUTPut[1]:DEEMphasis[:VALue][?] ”
on page 142
5 SCPI Command Reference
140 Agilent J-BERT N4903B High-Performance Serial BERT
Description