Technical data

Table 29
Name Description under
[:LEVel][:IMMediate]:HIGH[?] “[SOURce[1]]:VOLTage[:LEVel]
[:IMMediate]:HIGH[?] ” on page 131
[:LEVel][:IMMediate]:LOW[?] “[SOURce[1]]:VOLTage[:LEVel]
[:IMMediate]:LOW[?] ” on page 131
[:LEVel][:IMMediate]:OFFSet[?] “[SOURce[1]]:VOLTage[:LEVel]
[:IMMediate]:OFFSet[?] ” on page 131
[:LEVel]:LLEVel[?] “[SOURce[1]]:VOLTage[:LEVel]:LLEVel
[?] ” on page 131
:PROTection:RESet[?] “[SOURce
[1]]:VOLTage:PROTection:RESet ” on
page 132
:PROTection[:STATe][?] “[SOURce[1]]:VOLTage:PROTection
[:STATe][?] ” on page 132
[SOURce[1]]:VOLTage:ECL
IAgilentN490xPGOutput.LogicLevel (not IVI-compliant)
[SOURce[1]]:VOLTage:ECL
This command sets the data output values to those used for the ECL family.
Retained for backwards compatibility. Superseded by SOURce1:VOLTage:LLEVel
(see “[SOURce[1]]:VOLTage[:LEVel]:LLEVel[?] ” on page 131).
[SOURce[1]]:VOLTage[:LEVel][:IMMediate][:AMPLitude][?]
IAgilentN490xPGOutVoltage.VAmplitude (IVI-compliant)
[SOURce[1]]:VOLTage[:LEVel][:IMMediate][:AMPLitude] <NR3>
[SOURce[1]]:VOLTage[:LEVel][:IMMediate][:AMPLitude]?
5 SCPI Command Reference
130 Agilent J-BERT N4903B High-Performance Serial BERT
IVI-COM Equivalent
Syntax
Description
IVI-COM Equivalent
Syntax