Technical data

N O T E
This command must be used together with the “[SOURce
[1]]:PATTern:APCHange:MODE[?] ” on page 108 and “[SOURce
[1]]:PATTern:APCHange:SELect[?] ” on page 109.
For instructions on how to use these commands, refer to “How the Serial BERT
Uses Alternate Patterns” on page 55.
[SOURce[1]]:PATTern:SEQuence Subnode
This subnode has the following SCPI structure:
[SOURce[1]:]
:PATTern
:SEQuence
:DATa[?]
:EVENt
:RCL
:SAVe
:STATe?
This subnode has the following commands:
Table 18
Name Description under
:DATA[?] “[SOURce
[1]]:PATTern:SEQuence:DATA[?] ” on
page 112
:EVENt “[SOURce
[1]]:PATTern:SEQuence:EVENt ” on
page 116
:RCL “[SOURce[1]]:PATTern:SEQuence:RCL ”
on page 117
:SAVE “SOURce[1]:PATTern:SEQuence:SAVe ”
on page 117
:STATe “[SOURce
[1]]:PATTern:SEQuence:STATe? ” on
page 117
SCPI Command Reference 5
Agilent J-BERT N4903B High-Performance Serial BERT 111