Technical data

98 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
6 Status Reporting
Status Reporting Data Structures
The different status reporting data structures, descriptions, and
interactions are shown in Figure 3. To make it possible for any of the
Standard Event Status Register bits to generate a summary bit, you must
enable the corresponding bits. These bits are enabled by using the *ESE
common command to set the corresponding bit in the Standard Event
Status Enable Register.
To generate a service request (SRQ) interrupt to the computer, you must
enable at least one bit in the Status Byte Register. These bits are enabled
by using the *SRE common command to set the corresponding bit in the
Service Request Enable Register. These enabled bits can then set RQS and
MSS (bit 6) in the Status Byte Register.
For more information about common commands, see the "Common
Commands" chapter.
Figure 3 Status Reporting Data Structures