Technical data

834 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
31 Trigger Commands
:TRIGger:SHOLd:MODE
Command :TRIGger:SHOLd[{1 | 2}]:MODE {SETup | HOLD | SHOLd}
SETup When using the setup time mode, a time window is defined where the
right edge is the clock edge and the left edge is the selected time before
the clock edge. The waveform must stay outside of the trigger level
thresholds during this time window. If the waveform crosses a threshold
during this time window, a violation event occurs and the oscilloscope
triggers.
HOLD When using the hold time mode, the waveform must not cross the
threshold voltages after the specified clock edge for at least the hold time
you have selected. Otherwise, a violation event occurs and the oscilloscope
triggers.
SHOLd When using the setup and hold time mode, if the waveform violates either
a setup time or hold time, the oscilloscope triggers. The total time allowed
for the sum of setup time plus hold time is 24 ns maximum.
The optional [{1 | 2}] parameter sets whether the trigger mode goes with
the TERM1 or TERM2 state if sequential triggering is being used.
Query
:TRIGger:SHOLd:MODE?
The query returns the currently selected trigger setup violation mode.
Returned Format
[:TRIGger:SHOLd:MODE] {SETup | HOLD | SHOLd}<NL>