Technical data

Serial Bus Commands 26
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 685
:SBUS<N>:SPI:CLOCk:SLOPe
Command :SBUS<N>:SPI:CLOCk:SLOPe <slope>
<slope> ::= {POSitive | RISing | NEGative | FALLing}
The :SBUS<N>:SPI:CLOCk:SLOPe command specifies the rising edge
(POSitive) or falling edge (NEGative) of the SPI clock source that will
clock in the data.
<N> An integer, 1 - 4.
Query
:SBUS<N>:SPI:CLOCk:SLOPe?
The :SBUS<N>:SPI:CLOCk:SLOPe? query returns the current SPI clock
source slope.
Returned Format
[:SBUS<N>:SPI:CLOCk:SLOPe] <slope><NL>
<slope> ::= {RIS | FALL}
See Also • ":SBUS<N>:SPI:CLOCk:TIMeout" on page 686
• ":SBUS<N>:SPI:SOURce:CLOCk" on page 688