Technical data

Root Level Commands 25
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 665
:RUN
Command :RUN
The :RUN command starts the oscilloscope running. When the oscilloscope
is running, it acquires waveform data according to its current settings.
Acquisition runs repetitively until the oscilloscope receives a :STOP
command, or until there is only one acquisition if Trigger Sweep is set to
Single. However, the :TRIGger:SWEep SINGle should not be used in new
programs. The :SINGle command should be used instead to acquire a
single acquisition.
Example This example causes the oscilloscope to acquire data repetitively.
myScope.WriteString ":RUN"