Technical data

Measure Commands 24
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 593
:MEASure:TEDGe
Command :MEASure:TEDGe <meas_thres_txt>,[<slope>]<occurrence>[,<source>]
The :MEASure:TEDGe command measures the time interval between the
trigger event and the specified edge (threshold level, slope, and transition).
Sources are specified with the :MEASure:SOURce command or with the
optional parameter following the :MEASure:TEDGe command.
<meas_thres
_txt>
UPPer, MIDDle, or LOWer to identify the threshold.
<slope> { - (minus) for falling | + (plus) for rising | <none> (the slope is optional;
if no slope is specified, + (plus) is assumed) }
<occurrence> An integer value representing the edge of the occurrence. The desired edge
must be present on the display. Edges are counted with 1 being the first
edge from the left on the display, and a maximum value of 65534.
<source> {CHANnel<N> | FUNCtion<N> | WMEMory<N> | CLOCk | MTRend |
MSPectrum | EQUalized}
MTRend and MSPectrum sources are only available if the oscilloscope has
the EZJIT option installed and the feature is enabled.
The CLOCk source is only available if the oscilloscope has the High Speed
Serial option installed and the feature is enabled.
The EQUalized source is only available if the oscilloscope has the High
Speed Serial option and the Serial Data Equalization option installed and
the features are enabled. This command uses the Feed- Forward Equalized
(FFE) signal as the source.
<N> CHANnel<N> is an integer, 1 - 4.
FUNCtion<N> and WMEMory<N> are:
An integer, 1 - 4, representing the selected function or waveform memory.
Query
:MEASure:TEDGe? <meas_thres_txt>,
<slope><occurrence> [,<source>]
The :MEASure:TEDGe? query returns the time interval between the trigger
event and the specified edge (threshold level, slope, and transition).
Returned Format
[:MEASure:TEDGe] <time>[,<result_state>]<NL>
<time> The time interval between the trigger event and the specified voltage level
and transition.
<result_state> If SENDvalid is ON, the result state is returned with the measurement
result. See the :MEASure:RESults table in this chapter for a list of the
result states.