Technical data

Measure Commands 24
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 577
:MEASure:RJDJ:INTerpolate
Command
:MEASure:RJDJ:INTerpolate {LINear | NONE}
The :MEASure:RJDJ:INTerpolate command sets the interpolation mode
used for the RJDJ measurements.
Example This example sets the RJDJ interpolation to use both linear.
myScope.WriteString ":MEASURE:RJDJ:INTERPOLATE LINEAR"
Query :MEASure:RJDJ:INTerpolate?
The :MEASure:RJDJ:INTerpolate? query returns the edge being used for the
RJDJ measurements.
Returned Format
[:MEASure:RJDJ:INTerpolate] {LINear | NONE}<NL>
Example This example places the current interpolation mode being used for RJDJ
measurements in the interpolate variable and displays it on the computer's
screen.
myScope.WriteString ":SYSTEM:HEADER OFF" ' Response headers off.
myScope.WriteString ":MEASURE:RJDJ:INTERPOLATE?"
varinterpolate = myScope.ReadNumber
Debug.Print FormatNumber(varinterpolate, 0)
NOTE
This command is only available when the N5400A/N5401A Software is installed.