Technical data

Measure Commands 24
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 441
:MEASure:VTOP 638
:MEASure:VUPPer 639
:MEASure:WINDow 641
The commands in the MEASure subsystem are used to make parametric
measurements on displayed waveforms.
E2688A High
Speed Serial
Software
commands
The following MEASure commands are available when the E2688A High
Speed Serial Software is installed.
• ":MEASure:CLOCk" on page 458
• ":MEASure:CLOCk:METHod" on page 459
• ":MEASure:CLOCk:METHod:ALIGn" on page 461
• ":MEASure:CLOCk:METHod:DEEMphasis" on page 462
• ":MEASure:CLOCk:VERTical" on page 463
• ":MEASure:CLOCk:VERTical:OFFSet" on page 464
• ":MEASure:CLOCk:VERTical:RANGe" on page 465
• ":MEASure:TIEData" on page 607
• ":MEASure:TIEFilter:STARt" on page 609
• ":MEASure:TIEFilter:STATe" on page 610
• ":MEASure:TIEFilter:STOP" on page 611
• ":MEASure:TIEFilter:TYPE" on page 612
• Also see the ":MTESt:FOLDing" on page 414 command in the mask test
system.
E2681A EZJIT
Jitter Analysis
Software
commands
The following MEASure commands are available when the E2681A EZJIT
Jitter Analysis Software is installed.
• ":MEASure:CTCDutycycle" on page 467
• ":MEASure:CTCJitter" on page 469
• ":MEASure:CTCNwidth" on page 471
• ":MEASure:CTCPwidth" on page 473
• ":MEASure:DATarate" on page 475
• ":MEASure:DDPWS" on page 477
• ":MEASure:HOLDtime" on page 513
• ":MEASure:JITTer:HISTogram" on page 515
• ":MEASure:JITTer:MEASurement" on page 516
• ":MEASure:JITTer:SPECtrum" on page 517