Technical data

What's New 1
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 33
What's New in Version 3.10
New command descriptions for Version 3.10 of the Infiniium
90000A/90000X Series oscilloscope software appear below.
New Commands
Command Description
:CHANnel<N>:PROBe:ACCal
(see page 198)
Sets the type of AC response probe calibration to use.
:CHANnel<N>:PROBe:PRECpr
obe:BANDwidth (see
page 216)
Specifies how the limit of PrecisionProbe or PrecisionCable
correction/boosting is determined..
:CHANnel<N>:PROBe:PRECpr
obe:CALibration (see
page 217)
Specifies the name of the PrecisionProbe or PrecisionCable
calibration to use for the specified channel and probe.
:CHANnel<N>:PROBe:PRECpr
obe:MODE (see page 218)
Selects between PrecisionProbe or PrecisionCable AC response
probe calibration.
:CHANnel<N>:PROBe:PRECpr
obe:ZSRC (see page 219)
Specifies how PrecisionProbe characterizes the time domain
and frequency domain response.
:DISPlay:STATus:COL (see
page 281)
Used to position the real time eye and InfiniiScan Zone Trigger
status labels.
:DISPlay:STATus:ROW (see
page 282)
Used to position the real time eye and InfiniiScan Zone Trigger
status labels.
:MEASure:DDPWS (see
page 477)
For measuring Data Dependent Pulse Width Shrinkage.
:MEASure:EDGE (see
page 484)
For measuring the edge time relative to the reference location.
:MEASure:JITTer:SPECtrum:V
ERTical:TYPE (see page 524)
Lets you select either a LINear or a LOGarithmic vertical scale
for the jitter spectum plot.
:MEASure:RJDJ:APLength?
(see page 572)
Returns the determined RjDj pattern length.
:SPRocessing:CTLequalizer:N
UMPoles (see page 704)
Selects either a 2 Pole or 3 Pole Continuous Time Linear
Equalization.
:SPRocessing:CTLequalizer:P3
(see page 707)
Sets the Pole 3 frequency for the Continuous Time Linear
Equalization.