Technical data

314 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
16 Function Commands
:FUNCtion<N>:MHIStogram
Command :FUNCtion<N>:MHIStogram {MEAS1 | MEAS2 | MEAS3 | MEAS4 | MEAS5}
The :FUNCtion<N>:MHIStogram command adds a Meas Histogram function
that shows a histogram of measurement values. Measurement values are
captured and the histogram is updated as new acquisitions are made.
You can display statistics for the histogram in the Measurements tab using
the :MEASure:HISTogram commands and you can get histogram statistics
using the :MEASure:HISTogram queries.
<N> An integer, 1 - 4, representing the selected function.
Example This example sets up a histogram function of the first measurement.
myScope.WriteString ":FUNCtion2:MHIStogram MEAS1"
See Also • ":MEASure:HISTogram:HITS" on page 500
• ":MEASure:HISTogram:M1S" on page 501
• ":MEASure:HISTogram:M2S" on page 502
• ":MEASure:HISTogram:M3S" on page 503
• ":MEASure:HISTogram:MAX" on page 504
• ":MEASure:HISTogram:MEAN" on page 505
• ":MEASure:HISTogram:MEDian" on page 506
• ":MEASure:HISTogram:MIN" on page 507
• ":MEASure:HISTogram:MODE" on page 508
• ":MEASure:HISTogram:PEAK" on page 509
• ":MEASure:HISTogram:PP" on page 510
• ":MEASure:HISTogram:RESolution" on page 511
• ":MEASure:HISTogram:STDDev" on page 512