Technical data

Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 3
In This Book
This book is your guide to programming the Infiniium 90000 Series
oscilloscopes These oscilloscopes include the 90000A Series, the
90000 X-Series, and the 90000 Q- Series.
Chapter 1, “What's New,” starting on page 27, describes programming
command changes in the latest version of oscilloscope software.
Chapter 2, “Setting Up,” starting on page 35, describes the steps you must
take before you can control the oscilloscope with remote programs.
The next several chapters give you an introduction to programming the
oscilloscopes, along with necessary conceptual information. These chapters
describe basic program communications, interface, syntax, data types, and
status reporting:
• Chapter 3, “Introduction to Programming,” starting on page 43
• Chapter 4, “LAN, USB, and GPIB Interfaces,” starting on page 79
• Chapter 5, “Message Communication and System Functions,” starting on
page 91
• Chapter 6, “Status Reporting,” starting on page 95
• Chapter 7, “Remote Acquisition Synchronization,” starting on page 119
• Chapter 8, “Programming Conventions,” starting on page 129
The next chapters describe the commands used to program the
oscilloscopes. Each chapter describes the set of commands that belong to
an individual subsystem, and explains the function of each command.
• Chapter 9, “Acquire Commands,” starting on page 139
• Chapter 10, “Bus Commands,” starting on page 163
• Chapter 11, “Calibration Commands,” starting on page 165
• Chapter 12, “Channel Commands,” starting on page 171
• Chapter 13, “Common Commands,” starting on page 227
• Chapter 14, “Disk Commands,” starting on page 249
• Chapter 15, “Display Commands,” starting on page 267
• Chapter 16, “Function Commands,” starting on page 287
• Chapter 17, “Hardcopy Commands,” starting on page 329
• Chapter 18, “Histogram Commands,” starting on page 335
• Chapter 19, “InfiniiScan (ISCan) Commands,” starting on page 347
• Chapter 20, “Limit Test Commands,” starting on page 369
• Chapter 21, “Lister Commands,” starting on page 377
• Chapter 22, “Marker Commands,” starting on page 381
• Chapter 23, “Mask Test Commands,” starting on page 393
• Chapter 24, “Measure Commands,” starting on page 437