Technical data

What's New 1
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 29
What's New in Version 3.50
New command descriptions for Version 3.50 of the Infiniium
90000A/90000X Series oscilloscope software appear below.
New Commands
Command Description
:CHANnel<N>:PROBe:AUToze
ro (see page 200)
Initiates the N2893A probe's auto degauss/ offset cal.
:CHANnel<N>:PROBe:HEAD:
VTERm (see page 213)
Sets the termination voltage for the N5444A probe head.
:CHANnel<N>:PROBe:MODE
(see page 215)
Sets the N2750A probe's InfiniiMode configuration.
:FUNCtion<N>:MTRend (see
page 316)
New Meas Trend math function.
:FUNCtion<N>:MHIStogram
(see page 314)
New Meas Histogram math function.
:LISTer Commands (see
page 377)
For displaying and retreiving data from the serial decode listings.
:MEASure:HISTogram:RESolut
ion (see page 511)
The bin width value of one bar in the histogram.
:MEASure:NOISe (see
page 536)
Adds a Noise measurement to the oscilloscope display (like
Measure > Data > Noise from the front panel) or gets the
measured noise value.
:MEASure:NOISe:ALL (see
page 537)
Returns the NOISe measurement results for the "zeros" or
"ones" level.
:MEASure:NOISe:BANDwidth
(see page 538)
Sets the type of filtering used to separate the data dependent
noise from the random noise and the periodic noise.
:MEASure:NOISe:LOCation
(see page 539)
Specifies the noise measurement location within the bit where
0% is the beginning of the bit, 50% is the middle of the bit, and
100% is the end of the bit.
:MEASure:NOISe:RN (see
page 540)
Specifies a known amount of random noise.
:MEASure:NOISe:SCOPe:RN
(see page 541)
Specifies the removal of the oscilloscope's calibrated random
noise from the reported RN.
:MEASure:NOISe:STATe (see
page 542)
Enables or disables the NOISe measurements.
:MEASure:NOISe:UNITs (see
page 543)
Sets the unit of measure for NOISe measurements to volts or
unit amplitude.
:MEASure:RJDJ:RJ (see
page 580)
Specifies a known amount of random jitter.