Manualshelf

Technical data

ManualsBrandsAgilent Technologies ManualsPower ToolsIniniium 90000
191192193194195196197198199200
200 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
12 Channel Commands
:CHANnel<N>:PROBe:AUTozero
Command :CHANnel<N>:PROBe:AUTozero
The :CHANnel<N>:PROBe:AUTOzero command initiates the N2893A probe's
auto degauss/ offset cal.
If the N2893A probe is not connected to the channel you will get a
settings conflict error.
<N> An integer, 1 - 4
Example This example performs an auto zero operation for the probe on channel 1.
myScope.WriteString ":CHANnel1:PROBe:AUTozero"
NOTE
This command is currently only valid for the N2893A probe.