Technical data

190 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
12 Channel Commands
:CHANnel<N>:ISIM:DELay
Command :CHANnel<N>:ISIM:DElay {OFF | ON}
If the :CHANnel<N>:ISIM:DELay command is turned on, the transfer
function delay is included in the resultant waveform. Consult the
InfiniiSim User's Guide in the Manuals section of the GUI help system for
more information.
<N> An integer, 1 - 4.
Example This example applies the transfer function delay in the resultant
waveform.
myScope.WriteString ":CHANNEL1:ISIM:DELay ON"
Query :CHANnel<N>:ISIM:DELay?
The :CHANnel<N>:ISIM:DELay? query returns the current state of the
transfer function delay feature on the corresponding input channel.
Returned Format
[CHANnel<N>:ISIM:DELay] {OFF | ON}<NL>
Example This example puts whether or not the transfer function delay is included
in the resultant waveform for channel 1 in the string variable, strDelay.
The program then prints the contents of the variable to the computer's
screen.
myScope.WriteString ":SYSTem:HEADer OFF"
myScope.WriteString ":CHANNEL1:ISIM:DELay?"
strDelay = myScope.ReadString
Debug.Print strDelay
NOTE
This CHANnel command only applies if you have purchased the InfiniiSim software
application.
NOTE
You can specify differential and/or common mode channels using the following convention.
If you have differential or common mode channels enabled (using either the
:CHANnel<N>:DIFFerential or :CHANnel<N>:COMMonmode commands) then:
•
:CHANnel1 would refer to the Channel 1 - Channel 3 differential channel
• :CHANnel2 would refer to the Channel 2 - Channel 4 differential channel
• :CHANnel3 would refer to the Channel 1 + Channel 3 common mode channel
• :CHANnel4 would refer to the Channel 2 + Channel 4 common mode channel