Specifications

Chapter 5: Replacing Assemblies
To remove and replace the acquisition boards/backplane/optional MSO assembly
94
9
Remove the attenuator power cable from each input channel attenuator and
route the cable through the grommet in the backplane (Figure 5- 30). The
attenuators are keyed to match the connectors.
Figure 5-30
10
Remove the rear panel BNCs (Figure 5- 31). The figure on the right shows the
rear panel with the optional MSO assembly.
Figure 5-31
Remove this connection from each channel attenuator
and then route the entire cable through the backplane boa