Specifications

Chapter 5: Replacing Assemblies
To remove and replace the acquisition boards/backplane/optional MSO assembly
93
7
Disconnect the two semi- rigid Cal Out/Aux Out cables from both the front panel
and backplane board. As Figure 5- 28 shows, first disconnect the cables from
the rear side of the Cal Out / Aux Out connections and then pull straight back
to remove the cables from the backplane board. CAUTION: Be sure to pull
straight back to avoid bending or breaking the connection to the backplane board.
When reconnecting these cables, torque the Cal Out/Aux Out connections to 8
in- lbs.
Figure 5-28
8
Disconnect each input cable and route them through the openings in the
backplane. (When reconnecting, you can determine the appropriate connections
by matching the colored o- ring to the bezel color. Tighten to 8 in- lbs using a
calibrated 5/16- inch open end torque wrench.)
Figure 5-29
Disconnect
here first