Specifications

Chapter 5: Replacing Assemblies
To remove and replace the acquisition boards/backplane/optional MSO assembly
91
4
Loosen the two screws located at the bottom of the power supply and then
push the power supply toward the side of the oscilloscope with the fans. With
it pushed to the side, you can tighten the screws back down into a set of new
holes to keep the power supply in place when you flip the oscilloscope over in
an upcoming step.
Figure 5-24
Figure 5-25
The first screw
to loosen
The second screw
to loosen
This is the hole
that you
tighten the screw
back into after
sliding the power
supply