Specifications

Chapter 5: Replacing Assemblies
To remove and replace the front panel assembly
84
Figure 5-12
8
Remove the six M3 screws that attach the side of the chassis and the front
panel assembly. (Torque to 5 in- lbs when installing and the screws must be
tightened in the order shown in Figure 5- 13 below.)
Figure 5-13
9
Tilt the front panel up to see the cables connected to it. Either disconnect them
from the front panel side of the connection or route the display cable, on/off
cable, and USB front/touch screen cable through the grommet on the chassis
after disconnecting them from the other side of their connections (Figure 5- 14).
Remove this connection from each channel attenuator
and then route the entire cable through the backplane b