Specifications

Chapter 5: Replacing Assemblies
To return the oscilloscope to Agilent Technologies for service
77
WARNING SHOCK HAZARD!
When the bulk 12V power supply is removed from the oscilloscope, two AC leads are
exposed. Therefore, the power cable should be disconnected from the bulk 12V power
supply before the supply is removed. Be careful to avoid contact with these leads as
severe shock could result.
To return the oscilloscope to Agilent Technologies for service
Before shipping the oscilloscope, contact an Agilent Technologies Service Center to
schedule service. To ship the oscilloscope, follow these steps:
1
Write the following information on a tag and attach it to the oscilloscope.
• Name and address of owner
• Oscilloscope model numbers
• Oscilloscope serial numbers
• Description of the service required or failure indications
2
Remove all accessories from the oscilloscope.
Accessories include all cables. Do not include accessories unless they are associated
with the failure symptoms.
3
Protect the oscilloscope by wrapping it in plastic or heavy paper.
4 Pack the oscilloscope in foam or other shock- absorbing material and place it
in a strong shipping container.
You can use the original shipping materials or order materials from an Agilent
Technologies Sales Office. If neither is available, place 8 to 10 cm (3 to 4 inches) of
shock- absorbing material around the oscilloscope and place it in a box that does not
allow movement during shipping.
5
Seal the shipping container securely.
6 Mark the shipping container as FRAGILE.
In any correspondence, refer to the oscilloscope by model number and full serial number.