Specifications

Chapter 5: Replacing Assemblies
To remove and replace the hard disk drive
101
To remove and replace the hard disk drive
Use this procedure to remove and replace the hard disk drive. When necessary, refer
to other removal procedures. The graphics in this chapter are representative of the
oscilloscope at the time of this printing. Your unit may look different.
1
Disconnect the power cable and remove the cover and top plate as described
previously.
2 Disconnect the cables connected to the hard drive.
3 Remove the four M3 screws shown below. Tighten to 5 in- lbs when assembling.
Figure 5-41
4
Remove the M3 screw from the rear panel as shown below.
Figure 5-42